-->

Tuesday, December 6, 2011

More ReplayXD Videos

Over the last couple of weeks, I've done a bit more experimentation with the ReplayXD 1080 and the Camzilla mount. I've put it on a few mates cars while they've been out having some fun, and I've set it up as a fixed camera and made a time lapse video as well.


This first video was the first time I fitted the camera to the outside of a car competing in a motorsport event. This is Franz Esterbauer's Mitsubishi Lancer Evo 8 MR, and he's competing in the first round of the McRae Motorsports Twilight Rallysprint Series, held at the Perth Motorplex. Franz has always done pretty well at these events, and this run was no exception, Franz's quickest run of the night, it was also good enough to help him win the event. The experimentation side of things, saw me running the camera with an exposed microphone opening, which I have since realised was not such a good idea, and as a result, I've had to overdub this video with some music to hide the deathly silence left behind after I muted the sound from the ReplayXD the instant Franz leaves the start line. If you want an idea of how bad the wind noise was, watch the video to the very end, as I left the original audio intact as Franz drives off from the stop control.


The next video we have today is from Gerrin Good's 'TYAFRYA' burnout car. TYAFRYA is a methanol fueled Ford XE Falcon, and Gerrin's certainly not afraid to swing the big ol' girl around on the burnout pad. For this video, I had covered the microphone opening with a small sticker, supplied by ReplayXD with the camera for that purpose, I also turned down the microphone gain to 25db to see if that helped. As you will pick up while watching the video, there are still some noise issues with this setup, either wind noise or the sticker vibrating.


For the next attempt, I replaced the flimsy sticker with some good old race tape and fixed the ReplayXD 1080 to the side of Nathan Hollis' "TANK" burnout Sigma. This is where I'd wanted to put the camera on Gerrin's car too, as you get a good view of the drivers hands during the burnout (and while that looked good on Franz's car, it works even better on a burnout car), however, TYAFRYA has stickers on the rear windows, and that causes some issues with the suction cups on the Camzilla clamp. As you will notice in the video, there's still some wind noise or vibration issues, but they seem to be getting a bit better.


The final clip for this blog post, is a time lapse video that I shot with the ReplayXD 1080 and Camzilla rig at the Perth Motorplex's December 2011 round of the Australian Top Fuel Championship. I mounted the camera to the glass inside race control, and set the ReplayXD to shoot 1 shot every 3 seconds. The camera managed to fill it's 4 gigabyte card in around 2.5 hours, and I resized, cropped and compiled the results into the video above.

No comments:

Post a Comment

Advertising